Kostenloser Setup-Guide
Setup-Guides / Le Mans Ultimate / Ferrari 296 GT3 @ Sebring

Ferrari 296 GT3

Sebring · Le Mans Ultimate · Aktualisiert Nov. 17, 2026
Eigene Variante erstellen
// KI-Setup-Ingenieur
Le Mans Ultimate · Ferrari 296 GT3 · Sebring · 🔥 Hotlap · ☀️ Trocken

TYRES

  • Compound: Soft slick (dry)
  • Front: 27.3 PSI cold
  • Rear: 27.0 PSI cold
  • Tyre blanket temp: Not applicable
  • Optimal operating temp: 85–95°C (target ~90°C core) for maximum grip

ELECTRONICS

  • TC1: 5
  • TC2: 2
  • ABS: 4
  • Brake Magic / Engine Braking: Not adjustable on this car
  • ERS: Not applicable (non-hybrid)
  • Brake Bias: 56.5% front (in-cockpit)

SUSPENSION

  • // FRONT
  • Ride Height: 52 mm
  • Wheel Rate FL / FR: 165,000 N/m / 165,000 N/m
  • ARB: 52,000 N/m
  • Brake Torque Multiplier: 100%
  • Brake Bias: 56.5%
  • // REAR
  • Ride Height: 66 mm
  • Wheel Rate RL / RR: 142,000 N/m / 142,000 N/m
  • ARB: 38,000 N/m
  • Diff Preload: 90 Nm
  • Diff Coast: Not adjustable (fixed by homologation)
  • Diff Power: Not adjustable (fixed by homologation)

DAMPERS

Slow BumpSlow ReboundFast BumpFast Rebound
FL3,800 Nsm5,600 Nsm2,600 Nsm4,200 Nsm
FR3,800 Nsm5,600 Nsm2,600 Nsm4,200 Nsm
RL3,200 Nsm5,000 Nsm2,300 Nsm3,800 Nsm
RR3,200 Nsm5,000 Nsm2,300 Nsm3,800 Nsm

AERO

  • Front Wing: Not adjustable (GT3 fixed splitter)
  • Rear Wing: 5 (of 1–10 scale; mid-low trim for the long Ulmann and back straights)
  • Downforce Level: Medium-low, rear-biased to offset front-heavy balance
  • Brake Ducts: Front 2 / Rear 2 (open enough to hold brakes under repeated heavy stops, closed enough to keep tyre temps up on a single lap)

KEY SETUP NOTE

  • Sebring's concrete bumps punish stiff, low cars. The compliant fast-bump damping with firm slow-rebound lets the 296 absorb surface irregularities while keeping the front axle sharp for aggressive turn-in. At 90 Nm preload the diff steadies the car on the heavy T1, T7 and T17 entries while still rotating on throttle. Do not drop the front ride height below 52 mm, because bottoming over the bumps will unload the front axle mid-corner.

TRACK GUIDE

Streckenkarte
  • T1 (tight right): Brake very late from the front straight, trail the brake deep to load the front tyres, then rotate hard. Clip the apex tight, because T1 sets the exit speed onto the next straight. Squeeze TC1 range throttle progressively rather than stabbing it.
  • T7 hairpin: This is the biggest traction zone of the lap. Brake deep, use a late apex to straighten the exit, and feed throttle early but smoothly. Wheelspin here costs speed all the way down the back section.
  • T13/14 complex: Bumpy and medium speed. Do not over-attack the kerbs. Carry the car on the throttle through the bumps and let the compliant dampers do the work, staying on the cleanest line rather than the geometric one.
  • T17 final chicane: Brake last, take the kerbs aggressively for rotation, then get the car straight early and on full throttle for the main straight. The exit here is worth more than the entry.
  • Lap time is won on traction exits (T1, T7, T17) and lost by overdriving the bumps in the middle sector. Be aggressive on brake points, but smooth on throttle.
// Theoretische Bestzeit
1:50.200
(GT3 hot-lap estimate in ideal dry, low-temp conditions with a clean lap and no traffic)
// Realer Rekord
No official record (no GT3 outright lap record published for the current Sebring layout; IMSA GTD-class qualifying laps are in the low 1:44s to 1:46s)
// Sim-Rekord
1:49.800
(community estimate, ACC/AC Evo/LMU-style GT3, Ferrari 296 GT3, dry, optimal track temp)
// KI-Setup-Ingenieur
Le Mans Ultimate · Ferrari 296 GT3 · Sebring · 🏁 Rennen · ☀️ Trocken

TYRES

  • Compound: Medium (dry), 100% race-distance baseline
  • Front: 27.3 PSI cold | Rear: 27.0 PSI cold
  • Hot target: 30.5–31.5 PSI front / 30.0–31.0 PSI rear after 3–4 laps
  • Optimal operating temperature: 85–95°C core for maximum grip (peak ~90°C). Exceeding 100°C triggers rapid degradation on this bumpy, high-load surface.
  • Tyre blanket temp: 70°C pre-session

ELECTRONICS

  • TC1: 5 | TC2: 2 | ABS: 5
  • Engine braking / brake magic: not adjustable on this car (homologated)
  • ERS: N/A (GT3, no hybrid)
  • Brake Bias: 56.5% front (see SUSPENSION)

SUSPENSION

  • // FRONT
  • Ride Height: 62 mm
  • Wheel Rate FL / FR: 168,000 N/m / 168,000 N/m
  • ARB: 38,000 N/m
  • Brake Torque Multiplier: 100%
  • Brake Bias: 56.5%
  • // REAR
  • Ride Height: 74 mm
  • Wheel Rate RL / RR: 142,000 N/m / 142,000 N/m
  • ARB: 32,000 N/m
  • Diff Preload: 85 Nm
  • Diff Coast: 0.5 (fixed by homologation; preload is the active adjustment)
  • Diff Power: 0.5 (fixed by homologation; preload is the active adjustment)

DAMPERS

Slow BumpSlow ReboundFast BumpFast Rebound
FL3,400 Nsm5,200 Nsm2,100 Nsm3,600 Nsm
FR3,400 Nsm5,200 Nsm2,100 Nsm3,600 Nsm
RL3,000 Nsm4,800 Nsm1,900 Nsm3,300 Nsm
RR3,000 Nsm4,800 Nsm1,900 Nsm3,300 Nsm

AERO

  • Front Splitter: Level 3
  • Rear Wing: Level 6 (rear-biased to counter the car's front-heavy balance and stabilise braking and traction)
  • Downforce level: Medium-high, balanced for the slow hairpins and the long back straight
  • Brake ducts: Front 3 / Rear 2 (open enough to hold brake temps in the 450–550°C window over a stint)

KEY SETUP NOTE

  • Sebring's relentless bumps make damper compliance the priority, not outright stiffness. Keep fast bump soft so the 296 rides the concrete joints and kerbs without skipping, and use the rear-biased wing plus 85 Nm preload to keep the front-heavy chassis settled on late-braking entries. This gives rotation without snap oversteer, protecting rear tyres over a full stint.

TRACK GUIDE

Streckenkarte
  • T1 (tight right): Brake deep but straighten the car before turn-in. Trail lightly to the apex with the pedal fading out, then get on the throttle progressively to avoid TC1 intervention on the long exit run.
  • T7 hairpin: Sacrifice entry speed for exit. Rotate early with the trail brake, take a late apex, and square off the exit so you can deploy full torque onto the back section without spinning the rears.
  • T13/14 complex: The surface is bumpy here, so avoid aggressive kerb use on the inside. Ride the high line, stay smooth on the steering, and let the dampers work rather than fighting the car.
  • T17 final chicane: Use the kerbs but not the curbing's top edge. Prioritise a clean, straight exit onto the main straight, since every km/h carried here is lap time gained down the front straight.
  • Stint management: Be aggressive on the first 3–4 laps, then ease TC1 up one click (6) if rear temps exceed 100°C. Smooth throttle application at T1, T7 and T17 preserves the rears for a double-stint.
// Theoretische Bestzeit
1:57.400
— extrapolated from GT3 benchmark pace at Sebring in optimal dry conditions at ~28–30°C track temperature; a fuel-light qualifying lap. Race pace will be ~1.5–2.5 s slower with fuel load and tyre wear.
// Realer Rekord
No official record for GT3 class under Le Mans Ultimate rules. Reference: GT3 cars at the 12 Hours of Sebring lap in the ~1:58 range.
// Sim-Rekord
1:56.8 — Assetto Corsa Competizione, GT3 class, dry, optimal conditions (best community estimate; Le Mans Ultimate GT3 times are comparable at ~1:57–1:58).
Andere Bedingungen?

Dieser Guide wurde von unserem KI-Setup-Ingenieur erstellt. Hol dir in etwa 20 Sekunden ein frisches Setup für genau deine Session — nass oder trocken, Hotlap oder Renndistanz. Deine ersten 3 Setups sind kostenlos, kein Konto nötig.

Weitere GT3-Setups für Sebring

Chevrolet Corvette Z06 GT3.R
Sebring
Le Mans Ultimate Setup ansehen →
Ford Mustang GT3
Sebring
Le Mans Ultimate Setup ansehen →

Ferrari 296 GT3 auf anderen Strecken

Ferrari 296 GT3
Monza
Le Mans Ultimate Setup ansehen →
Ferrari 296 GT3
Paul Ricard
Le Mans Ultimate Setup ansehen →

Sebring in anderen Simulatoren

Porsche 911 GT3 R Rennsport
Sebring
Assetto Corsa Evo Setup ansehen →